Alcatel-Lucent 7450 - MPLS-TP Path Configuration

MPLS and RSVP
7450 ESS MPLS Guide Page 95
to <a.b.c.d>
<lsp-name>
"lsp-32" "lsp-33" "lsp-34" "lsp-35" "lsp-36" "lsp-37" "lsp-38" "lsp-39"
"lsp-40" "lsp-41"
status {up|down}
from <ip-address>
detail
*A:mlstp-dutA# show router mpls tp-lsp "lsp-
"lsp-32" "lsp-33" "lsp-34" "lsp-35" "lsp-36" "lsp-37" "lsp-38" "lsp-39"
"lsp-40" "lsp-41"
*A:mlstp-dutA# show router mpls tp-lsp "lsp-32"
===============================================================================
MPLS MPLS-TP LSPs (Originating)
===============================================================================
LSP Name To Tun Protect Adm Opr
Id Path
-------------------------------------------------------------------------------
lsp-32 0.0.3.234 32 No Up Up
-------------------------------------------------------------------------------
LSPs : 1
===============================================================================
*A:mlstp-dutA# show router mpls tp-lsp "lsp-32" detail
===============================================================================
MPLS MPLS-TP LSPs (Originating) (Detail)
===============================================================================
-------------------------------------------------------------------------------
Type : Originating
-------------------------------------------------------------------------------
LSP Name : lsp-32
LSP Type : MplsTp LSP Tunnel ID : 32
From Node Id: 0.0.3.233+ To Node Id : 0.0.3.234
Adm State : Up Oper State : Up
LSP Up Time : 0d 04:50:47 LSP Down Time : 0d 00:00:00
Transitions : 1 Path Changes : 2
DestGlobalId: 42 DestTunnelNum : 32
MPLS-TP Path configuration.
This can reuse and augment the output of the current show commands for static LSPs. They
should also show if BFD is enabled on a given path. If this referring to a transit path, this should
also display (among others) the path-id (7 parameters) for a given transit-path-name, or the transit-
path-name for a given the path-id (7 parameters)
show>router>mpls>tp-lsp>path
A sample output is as follows:
===============================================================================
*A:mlstp-dutA# show router mpls tp-lsp path