Label Distribution Protocol
7450 ESS MPLS Guide Page 635
Modifying Targeted Session Parameters
The modification of LDP targeted session parameters does not take effect until the next time the
session goes down and is re-establishes. Individual parameters cannot be deleted. The
no form of
a targeted-session parameter command reverts modified values back to the default. Different
default parameters can be configured for IPv4 and IPv6 LDP targeted hello adjacencies.
The following example displays the command syntax usage to revert targeted session parameters
back to the default values:
Example:
config>router# ldp
config>router>ldp# targeted-session
config>router>ldp>tcp-session-parameters>peer# no authentication-key
config>router>ldp>targ-session# no disable-targeted-session
config>router>ldp>targ-session>ipv4# no hello
config>router>ldp>targ-session>ipv4# no keepalive
config>router>ldp>targ-session# no peer 10.10.10.104
The following output displays the default values:
A:ALA-1>config>router>ldp>targeted# info detail
----------------------------------------------
no disable-targeted-session
no import-prefixes
no export-prefixes
ipv4
no hello
no keepalive
no hello-reduction
exit
ipv6
no hello
no keepalive
no hello-reduction
exit
----------------------------------------------
A:ALA-1>config>router>ldp>targeted#
To Next Page
Loading...
