Alcatel-Lucent 7450 - Base Resource Handling Procedures

Label Distribution Protocol
7450 ESS MPLS Guide Page 591
Link Adjacencies : 0 Targeted Adjacencies : 1
Local Address : 110.20.1.110 Peer Address : 10.8.100.15
Local TCP Port : 0 Peer TCP Port : 0
Local KA Timeout : 40 Peer KA Timeout : 40
Mesg Sent : 0 Mesg Recv : 1
FECs Sent : 0 FECs Recv : 0
Addrs Sent : 0 Addrs Recv : 0
GR State : Capable Label Distribution : DU
Nbr Liveness Time : 0 Max Recovery Time : 0
Number of Restart : 0 Last Restart Time : Never
P2MP : Not Capable MP MBB : Not Capable
Dynamic Capability : Not Capable LSR Overload : Not Capable <---- /
/Peer OverLoad Capab.
Advertise : Address/Servi*
Addr FEC OverLoad Sent : No Addr FEC OverLoad Recv : No
Mcast FEC Overload Sent: No Mcast FEC Overload Recv: No
Serv FEC Overload Sent : No Serv FEC Overload Recv : No
-------------------------------------------------------------------------------
Base Resource Handling Procedures
Step 1
If the peer OR the local LSR does not support the Overload Protection Capability it means that the
associated adjacency [interface/peer] will be brought down as part of the base resource handling
mechanism.
The user can determine which interface or targeted peer was shut down, by applying the following
commands:
- [show router ldp interface resource-failures]
- [show router ldp targ-peer resource-failures]
show router ldp interface resource-failures
===============================================================================
LDP Interface Resource Failures
===============================================================================
srl srr
sru4 sr4-1-5-1
===============================================================================
show router ldp targ-peer resource-failures