Alcatel-Lucent 7450 - Debug Commands

LDP
7450 ESS MPLS Guide Page 797
Debug Commands
The following output shows debug LDP configurations discussed in this section.
A:ALA-12# debug router ldp peer 10.10.10.104
A:ALA-12>debug>router>ldp# show debug ldp
debug
router "Base"
ldp peer 10.10.10.104
event
bindings
messages
exit
packet
hello
init
keepalive
label
exit
exit
exit
exit
A:ALA-12>debug>router>ldp#
ldp
ldp
Syntax [no] ldp
Context debug>router
Description Use this command to configure LDP debugging.
interface
Syntax [no] interface interface-name family
Context debug>router>ldp
Description Use this command for debugging an LDP interface.
Parameters interface-name — The name of an existing interface.
family — Specifies the family type.
Values ipv4, ipv6