GMPLS Commands
Page 476 7450 ESS MPLS Guide
Default 0
Parameters seconds — Specifies the time, in seconds, for the LSP to attempt reversion after failure.
Values 0 — 1800
Default 0
shutdown
Syntax [no] shutdown
Context config>router>gmpls>lsp
Description This comand administratively enables or disables the GMPLS LSP.
Default shutdown
switching-type
Syntax switching-type switching-type
no switching-type
Context config>router>gmpls>lsp
Description This command configures the type of switching required for the gLSP. As defined in RFC 3471. The
default CLI value is ethernet, which indicates that Digital Channel Switch Capable (DCSC) should be
signaled. Ethernet is the only supported value in Release 13.0.
Default ethernet
Parameters switching-type — Specifies the required type of switching.
Values ethernet
to
Syntax to ip-address
Context config>router>gmpls>lsp
Description This command specifies the GMPLS loopback address of the far-end UNI-C router for a GMPLS
LSP. When creating a GMPLS LSP, this command is mandatory.
Parameters ip-address — Specifies the system IP address of the far-end UNI-C router.
To Next Page
Loading...
