GMPLS Commands
Page 472 7450 ESS MPLS Guide
GMPLS Commands
gmpls
Syntax [no] gmpls
Context config>router
Description This command enables the context to configure GMPLS parameters. GMPLS is not enabled by
default and must be explicitly enabled using no shutdown. The shutdown command
administratively disables GMPLS.
The no form of this command deletes this GMPLS protocol instance; this will remove all
configuration parameters for this GMPLS instance.
GMPLS must be shut down before the GMPLS instance can be deleted. If GMPLS is not shut down
when the no gmpls command is executed, a warning message on the console indicates that GMPLS
is still administratively up.
Default no gmpls
gr-helper-time
Syntax gr-helper-time max-recovery recovery-interval seconds max restart restart-interval
seconds
no gr-helper-time
Context config>router>gmpls
Description This command configures the local values for the max-recovery and the max-restart intervals used in
the RSVP Graceful Restart Helper feature when applied to a GMPLS UNI.
The values are configured globally in GMPLS.
The no version of this command re-instates the default value for the delay timer.
Default n/a
Parameters recovery-interval — Specifies the maximum recovery interval value, in seconds.
Values 1 — 1800
Default 300
restart-interval — Specifies the maximum restart interval value, in seconds.
Values 1 — 300
Default 180
To Next Page
Loading...
