GMPLS
7450 ESS MPLS Guide Page 473
keep-multiplier
Syntax keep multiplier number
no keep-multiplier
Context config>router>gmpls
Description This command configures the integer used by RSVP to declare that a reservation is down or the
neighbor is down.
The no form of this command reverts to the default value.
Default 3
Parameters number — Specifies the keep multiplier value.
Values 1 — 255
Default 3
lsp
Syntax [no] lsp lsp-name
Context config>router>gmpls
Description This command creates a GMPLS LSP that is signaled dynamically by the router.
When the LSP is created, the egress router must be specified using the to command and a working-
path must be specified.
GMPLS LSPs are created in the administratively down (shutdown) state.
The no form of this command deletes the GMPLS LSP. All configuration information associated with
this GMPLS LSP is lost. The GMPLS LSP must be administratively shut down before it can be
deleted.
Default n/a
Parameters lsp-name — Specifies the identifier for the GMPLS LSP. The LSP name can be up to 32 characters
long and must be unique.
e2e-protection-type
Syntax e2e-protection-type protection-type
no e2e-protection-type
Context config>router>gmpls>lsp
Description This command defines the end-to-end recovery type for the GLSP. This is the recovery model
between the source and terminating UNI-C nodes of the GMPLS LSP.
The no form of this command removes any configured end-to-end recovery, and the GMPLS LSP
becomes unprotected.
To Next Page
Loading...
