GMPLS Commands
Page 484 7450 ESS MPLS Guide
te-link
Syntax [no] te-link te-link-id
Context config>router>gmpls
Description This command enables the use of a Traffic Engineering (TE) Link (which has previously been
configured under config>router>lmp) in GMPLS.
The no form of this command reverts to the default value.
Default no te-link
Parameters te-link-id — Specifies the ID or name of the configured TE Link.
Values 1 — 4294967295 | te-link-name
te-link-name: 32 character maximum name of the TE Link
shutdown
Syntax [no] shutdown
Context config>router>gmpls>te-link
Description This command enables or disables the TE Link in GMPLS.
Default no shutdown
To Next Page
Loading...
