GMPLS
7450 ESS MPLS Guide Page 485
GMPLS Tunnel Group Commands
gmpls-tun-grp
Syntax [no] gmpls-tun-grp gmpls-tunnel-group-id
Context config
Description This command configures a GMPLS tunnel group. A GMPLS tunnel group is a bundle of GMPLS
LSPs providing an abstraction of the data bearers that are intended to be associated to one IP
interface. This object allows, for example, end-to-end load balancing across the set of data bearers
corresponding to a set of gLSPs. A gLSP is bound to an overlay tunnel group by a gLSP tunnel name
at both the head end and the tail end UNI-C nodes of a gLSP. A sender-address may be optionally
configured for the tail end of a gLSP in case overlapping GMPLS LSP tunnel names are used by
different head end nodes.
The no form of this command removes the tunnel group. All memebers of a GMPLS tunnel group
must be removed and the tunnel group shutdown before the tunnel group can be deleted.
Default no gmpls-tun-grp
Parameters gmpls-tunnel-group-id — Specifies the identifier of the GMPLS tunnel group.
Values 1 — 1024
description
Syntax description description-string
no description
Context config>gmpls-tun-grp
Description This command configures a description string for the GMPLS tunnel group.
The no form of this command removes the description.
Default no description
Parameters description-string — Specifies a text string of up to 160 characters describing the GMPLS tunnel
group.
far-end
Syntax far-end ip-address
no far-end
Context config>gmpls-tun-grp
Description This command configures the IP address (GMPLS Loopback Address) of the far-end UNI-C router.
To Next Page
Loading...
