GMPLS
7450 ESS MPLS Guide Page 481
peer
Syntax [no] peer peer-node-id
Context config>router>gmpls
Description This command specifies parameters for the RSVP session to a neighboring GMPLS UNI-N node.
The peer-node-id is the control plane identifier for the adjacent UNI-N node.
The no form of this command deletes the configuration.
Default n/a
Parameters peer-node-id — Specifies the control plane node ID of the neighboring GMPLS UNI-N node. This
can be an IP address or a 32-bit unsigned integer.
Values {a.b.c.d | 1 — 4294967295}
hello-interval
Syntax [no] hello-interval hello-interval
Context config>router>gmpls>peer
Description This command configures the RSVP hello packet interval, in milliseconds, towards the peer UNI-N
node.
The no form of this command sets the hello-interval to the default of 3000 milliseconds. A value of 0
disables RSVP hellos.
Default no hello-interval
Parameters hello-interval — Specifies the RSVP hello packet interval, in milliseconds.
Values 0 — 6000
Default 3000
lsp-hold-timer
Syntax [no] lsp-hold-timer hold-time
Context config>router>gmpls>peer
Description This command specifies the amount of time that the ingress node holds before programming its data
plane and declaring a GMPLS LSP up. This occurs anytime the ingress UNI-C node brings up a
GMPLS LSP path or reroutes a GMPLS LSP. The hold-time value should be configured to reflect the
data path programming time for the optical technology used between the ingress and egress UNI-N
nodes.
The no form of the command reverts the hold-timer to the default value.
Default no lsp-hold-timer
To Next Page
Loading...
