GMPLS Commands
Page 482 7450 ESS MPLS Guide
Parameters hold-timer — Specifies the ingress node hold time, in seconds.
Values 5 — 300
Default 60
shutdown
Syntax [no] shutdown
Context config>router>gmpls>peer
Description This command disables or enables RSVP adjaceny with the neighboring UNI-N peer node.
Default shutdown
rapid-retransmit-time
Syntax rapid-retransmit-time hundred-milliseconds
no rapid-retransmit-time
Context config>router>gmpls
Description This command configures the value of the Rapid Retransmission Interval. It is used in the re-
transmission mechanism to handle unacknowledged message_id objects and is based on an
exponential back-off timer.
Re-transmission interval of a RSVP message with the same message_id = 2 * rapid-retransmit-time
interval of time.
The node stops re-transmission of unacknowledged RSVP messages:
• if the updated back-off interval exceeds the value of the regular refresh interval, or
• if the number of re-transmissions reaches the value of the rapid-retry-limit parameter, which-
ever comes first
The Rapid Retransmission Interval must be smaller than the regular refresh interval configured in
config>router>gmpls>refresh-time.
The no form of this command reverts to the default value.
Default no rapid-retransmit-time
Parameters hundred-milliseconds — Specifies the Rapid Retransmission Interval, in units of 100 milliseconds.
Values 1 — 100
Default 5
To Next Page
Loading...
