LMP Commands
Page 466 7450 ESS MPLS Guide
control-channel
Syntax [no] control-channel lmp-cc-id
Context config>router>lmp>peer
Description This command enables the context for configuring an IP control channel for use by GNPLS UNI
control plane (RSVP and LMP).
Default no control-channel
Parameters lmp-cc-id — An unsigned integer identifier for the control channel.
Values 1 — 42949672
hello
Syntax hello [interval hello-interval] dead-interval hello-dead-interval
hello interval hello-interval [dead-interval hello-dead-interval]
Context config>router>lmp>peer>control-channel
Description This command configures the transmission interval for LMP Hello packets. The dead-interval
specifies the period after which the IPCC is declared down if no hello packets are received from the
LMP peer.
Default n/a
Parameters interval hello-interval — The interval at which LMP hello packets are sent on an IP control channel.
Values 1000 — 65535 milliseconds
Default 1000 milliseconds
dead-interval hello-dead-interval — The interval after which the IPCC is declared down if no hello
packets are received from the LMP peer.
Values 1000 — 65535 milliseconds
Default 1000 milliseconds
peer-interface-address
Syntax peer-interface-address ip-address
Context config>router>lmp>peer>control-channel
Description This command configures the mandatory peer-interface-address. It is the destination address of the
IPCC on the peer UNI-N used to reach the GMPLS Router ID of the UNI-N peer. It corresponds to
the lmpCcRemoteIpAddr in RFC 4631.
Default n/a
To Next Page
Loading...
