Alcatel-Lucent 7450 - Page 310

Page 310 7450 ESS MPLS Guide
dynamic — Displays dynamically assigned labels for bypass protection.
manual — Displays manually assigned labels for bypass protection.
detail — Displays detailed information.
p2mp — Displays P2MP bypass tunnel information.
Output MPLS Bypass Tunnel Output Fields — The following table describes MPLS bypass tunnel out-
put fields.
Sample Output
*A:Dut-B# show router mpls bypass-tunnel detail
=======================================================================
MPLS Bypass Tunnels (Detail)
=======================================================================
-----------------------------------------------------------------------
bypass-node10.20.1.4
-----------------------------------------------------------------------
To : 10.20.1.7 State : Up
Out I/F : 1/1/4 Out Label : 131071
Up Time : 0d 01:17:22 Active Time : n/a
Reserved BW : 0 Kbps Protected LSP Count : 1
Type : Dynamic
Setup Priority : 7 Hold Priority : 0
Class Type : 0
Exclude Node : 10.20.1.4 Inter-Area : True
Computed Hops :
10.10.8.2(S) Egress Admin Groups : None
-> 10.10.8.6(SA) Egress Admin Groups : None
-> 10.20.1.7(L) Egress Admin Groups : None
Actual Hops :
10.10.8.2(10.20.1.2) Record Label : N/A
-> 10.10.8.6(10.20.1.6) Record Label : 131071
-> 10.20.1.7(10.20.1.7) Record Label : 131068
-> 10.10.22.7 Record Label : 131068
=======================================================================
*A:Dut-A>config>router>mpls>lsp$ /show router mpls bypass-tunnel detail
=======================================================================
MPLS Bypass Tunnels (Detail)
Label Description
To
The system IP address of the egress router.
State
The LSP’s administrative state.
Out I/F
Specifies the name of the network IP interface.
Out Label
Specifies the incoming MPLS label on which to match.
Reserved BW (Kbps)
Specifies the amount of bandwidth in megabits per second (Mbps)
reserved for the LSP.