Alcatel-Lucent 7450 - Page 234

MPLS Commands
Page 234 7450 ESS MPLS Guide
Parameters in-label — Specifies the incoming MPLS label on which to match.
Values 32 — 1023
pop
Syntax [no] pop
Context config>router>mpls>if>label-map
Description This command specifies that the incoming label must be popped (removed). No label stacking is
supported for a static LSP. The service header follows the top label. Once the label is popped, the
packet is forwarded based on the service header.
The no form of this command removes the pop action for the in-label.
Default none
shutdown
Syntax [no] shutdown
Context config>router>mpls>if>label-map
Description This command disables the label map definition. This drops all packets that match the specified in-
label specified in the label-map in-label command.
The no form of this command administratively enables the defined label map action.
Default no shutdown