MPLS Commands
Page 238 7450 ESS MPLS Guide
oam-template
Syntax [no] oam-template name
Context config>router>mpls>mpls-tp
Description This command creates or edits an OAM template Generally applicable proactive OAM parameters
are configured using templates. The top-level template is the OAM template.
Generic MPLS-TP OAM and fault management parameters are configured in the OAM Template.
Proactive CC/CV uses BFD and parameters such as Tx/Rx timer intervals, multiplier and other
session/fault management parameters specific to BFD are configured using a BFD Template, which
is referenced from the OAM template.
Default no oam-template
Parameters name — Specifies a text string name for the template of up to 32 characters in printable 7-bit ASCII,
enclosed in double quotes. Named OAM templates are referenced from the MPLS-TP path MEP
configuration.
hold-time-down
Syntax hold-time-down timer
no hold-time-down
Context config>router>mpls>mpls-tp>oam-template
Description This command configures the hold-down dampening timer. It is equivalent to a hold-off timer.
Default no hold-time-down
Parameters interval — Specifies the hold-down dampening timer interval.
Values 0 — 5000 deciseconds in 10 ms increments
hold-time-up
Syntax hold-time-up timer
no hold-time-up
Context config>router>mpls>mpls-tp>oam-template
Description This command configures the hold-up dampening timer. This can be used to provide additional
dampening to the state of proactive CC BFD sessions.
Default no hold-time-up
Parameters interval — Specifies the hold-up dampening timer interval.
Values 0 — 500 deciseconds, in 100 ms increments
Default 2 seconds
To Next Page
Loading...
