MPLS Commands
Page 240 7450 ESS MPLS Guide
wait-to-restore
Syntax wait-to-restore interval
no wait-to-restore
Context config>router>mpls>mpls-tp>protection-template
Description This command configures the WTR timer. It determines how long to wait until the active path of an
MPLS-TP LSP is restored to the working path following the clearing of a defect on the working path.
It is appliable to revertive mode, only.
Default no wait-to-restore
Parameters interval — Specifies the WTR timer interval.
Values 0 — 720 seconds in 1 second increments
rapid-psc-timer
Syntax rapid-psc-timer interval
no rapid-psc-timer
Context config>router>mpls>mpls-tp>protection-template
Description This command configures the rapid timer value to be used for protection switching coordination
(PSC) packets for MPLS-TP linear protection (RFC 6378).
Default no rapid-psc-timer
Parameters interval — Specifies the rapid timer interval.
Values [10, 100, 1000 ms]
Default 10 ms
slow-psc-timer
Syntax slow-psc-timer interval
no slow-psc-timer
Context config>router>mpls>mpls-tp>protection-template
Description This command configures the slow timer value to be used for protection switching coordination
(PSC) packets for MPLS-TP linear protection (RFC 6378).
Default no rapid-psc-timer
Parameters interval — Specifies the slow timer interval.
Values [10, 100, 1000 ms]
To Next Page
Loading...
