MPLS Commands
Page 256 7450 ESS MPLS Guide
in-label
Syntax in-label in-label
no in-label
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command configures the incoming label for the reverse path or the working path or the protect
path of an MPLS-TP LSP. MPLS-TP LSPs are bidirectional, and so an incoming label value must be
specified for each path.
Default no in-label
Parameters in-label — Specifies the in label.
Values 32 — 16415
out-label
Syntax out-label out-label out-link if-name [next-hop ip-address]
no out-label
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command configureds the outgoing label value to use for an MPLS-TP working or protect path.
The out-link is the outgoing interface on the node that this path will use, and must be specified. If the
out-link refers to a numbered IP interface, the user may optionally configure the next-hop parameter
and the system will determine the interface to use to reach the configured next-hop, but will check
that the user-entered value for the out-link corresponds to the link returned by the system. If they do
not correspond, then the path will not come up.
Default no out-label
Parameters out-label — Specifies the out label.
Values 32 — 16415
if-name — Specifies the interface name.
ip-address — Specifies the IPv4 address in a.b.c.d
To Next Page
Loading...
