MPLS and RSVP
7450 ESS MPLS Guide Page 261
bandwidth
Syntax bandwidth rate-in-mbps
no bandwidth
Context config>router>mpls>lsp>fast-reroute
Description This command is used to request reserved bandwidth on the detour path. When configuring an LSP,
specify the traffic rate associated with the LSP.
When configuring fast reroute, allocate bandwidth for the rerouted path. The bandwidth rate does not
need to be the same as the bandwidth allocated for the LSP.
Default no bandwidth — Bandwidth is not reserved for a rerouted path.
Parameters rate-in-mbps — Specifies the amount of bandwidth in Mbps to be reserved for the LSP path.
hop-limit
Syntax hop-limit limit
no hop-limit
Context config>router>mpls>lsp>fast-reroute
Description For fast reroute, how many more routers a detour is allowed to traverse compared to the LSP itself.
For example, if an LSP traverses four routers, any detour for the LSP can be no more than ten router
hops, including the ingress and egress routers.
Default 16
Parameters limit — Specify the maximum number of hops.
Values 0 — 255
node-protect
Syntax [no] node-protect
Context config>router>mpls>lsp>fast-reroute
Description This command enables or disables node and link protection on the specified LSP. Node protection
ensures that traffic from an LSP traversing a neighboring router will reach its destination even if the
neighboring router fails.
Default node-protect
To Next Page
Loading...
