MPLS Commands
Page 284 7450 ESS MPLS Guide
to
Syntax to ip-address
Context config>router>mpls>static-lsp
Description This command specifies the system IP address of the egress router for the static LSP. When creating
an LSP this command is required. For LSPs that are used as transport tunnels for services, the to IP
address must be the system IP address. If the to address does not match the SDP address, the LSP is
not included in the SDP definition.
Parameters ip-address — The system IP address of the egress router.
Default none
To Next Page
Loading...
