MPLS and RSVP
7450 ESS MPLS Guide Page 297
refresh-time
Syntax refresh-time seconds
no refresh-time
Context config>router>rsvp
Description The refresh-time controls the interval, in seconds, between the successive Path and Resv refresh
messages. RSVP declares the session down after it misses keep-multiplier number consecutive
refresh messages.
The no form of this command reverts to the default value.
Default 30 seconds
Parameters seconds — The refresh time in seconds.
Values 1 — 65535
te-threshold-update
Syntax [no] te-threshold-update
Context config>router>rsvp
Description This command is used to control threshold-based IGP TE updates. The te-threshold-update
command must enable IGP TE update based only on bandwidth reservation thresholds per interface
and must block IGP TE update on bandwidth changes for each reservation. Threshold levels can be
defined using the te-up-threshold and te-down-threshold commands at the global RSVP or per-
interface level.
The no form of this command should reset te-threshold-update to the default value and disable
threshold based update.
Default no te-threshold-update
on-cac-failure
Syntax [no] on-cac-failure
Context config>router>rsvp>te-threshold-update
Description This command is used to enable a CAC failure-triggered IGP update.
The no form of this command should reset on-cac-failure to the default value and disable the CAC
failure-triggered IGP update.
Default no on-cac-failure
To Next Page
Loading...
