Page 370 7450 ESS MPLS Guide
status
Syntax status
Context show>router>mpls
Description This command displays MPLS operation information.
Output MPLS Status Output — The following table describes MPLS status output fields.
Sample Output
*A:SR-1/Dut-A# /show router mpls status
=======================================================================
MPLS Status
=======================================================================
Admin Status : Up Oper Status : Up
Oper Down Reason : n/a
FR Object : Enabled Resignal Timer : Disabled
Hold Timer : 1 seconds Next Resignal : N/A
Srlg Frr : Disabled Srlg Frr Strict : Disabled
Label Description
Admin Status
Down — MPLS is administratively disabled.
Up — MPLS is administratively enabled.
Oper Status
Down — MPLS is operationally down.
Up — MPLS is operationally up.
LSP Counts
Static LSPs — Displays the count of static LSPs that originate,
transit, and terminate on or through the router.
Dynamic LSPs — Displays the count of dynamic LSPs that origi-
nate, transit, and terminate on or through the router.
Detour LSPs — Displays the count of detour LSPs that originate,
transit, and terminate on or through the router.
FR Object
Enabled — Specifies that Fast reroute object is signaled for the
LSP.
Disabled — Specifies that Fast reroute object is not signaled for
the LSP.
Resignal Timer
Enabled — Specifies that the resignal timer is enabled for the LSP.
Disabled — Specifies that the resignal timer is disabled for the
LSP.
Hold Timer
Displays the amount of time that the ingress node holds before
programming its data plane and declaring the LSP up to the service
module.
To Next Page
Loading...
