Alcatel-Lucent 7450 - Page 487

GMPLS
7450 ESS MPLS Guide Page 487
shutdown
Syntax [no] shutdown
Context config>gmpls-tun-grp>member
Description This command disables or enables the member of the GMPLS tunnel group.
Default shutdown
member-threshold
Syntax [no] member-threshold threshold
Context config>gmpls-tun-grp
Description The member-threshold is the number of member GMPLS LSPs that must be operationally up before
the GMPLS tunnel group is considered operationally up. If that number is not reached, then the
GMPLS tunnel group is taken operationally down.
A member of a GMPLS tunnel group may be treated as down for one of the following reasons. These
reason codes are recorded in the tmnxGmplsTunGrpMemberTable in the MIB:
• adminDn — The member or the related tunnel group is admin down.
• wpLspDn — The associated GMPLS LSP working path is down.
• wpPortDn — The data-bearer port associated with the GMPLS LSP working path is down.
• wpPortNoRsrc — The data bearer port associated with the LSP working path has no resource to
support the services over the GMPLS tunnel group logical port.
• ppLspDn — The associated GMPLS LSP protect path is down.
• ppPortDn — The data-bearer port associated with the GMPLS LSP protect path is down.
• ppPortNoRsrc — The data bearer port associated with the GMPLS LSP protect path has no
resource to support the services over the GMPLS tunnel group logical port.
The no form of this command reverts the member threshold to 0.
Default 0
Parameters threshold — Specifies the minimum number of GMPLS LSPs that must be operationally up before
the GMPLS tunnel group is considered operationally up.
Values 0 — 15
mode
Syntax mode mode
Context config>gmpls-tun-grp
Description This command sets the operating mode of the GMPLS tunnel group.