EasyManua.ls Logo

Alcatel-Lucent 7450 - Page 670

Alcatel-Lucent 7450
816 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 670 7450 ESS MPLS Guide
export-addresses
Syntax export-addresses policy-name [policy-name...(up to 5 max)]
no export-addresses
Context config>router>ldp>session-parameters>peer
Description This command specifies the export prefix policy to local addresses advertised to this peer.
Policies are configured in the config>router>policy-options context. A maximum of five policy
names can be specified.
The no form of the command removes the policy from the configuration.
Parameters policy-name — The export-prefix route policy name. Allowed values are any string up to 32
characters long composed of printable, 7-bit ASCII characters excluding double quotes. If the
string contains spaces, use double quotes to delimit the start and end of the string. The specified
name(s) must already be defined.
export-prefixes
Syntax [no] export-prefixes policy-name
Context config>router>ldp>session-parameters>peer
Description This command specifies the export route policy used to determine which prefixes received from other
LDP and T-LDP peers are re-distributed to this LDP peer via the LDP/T-LDP session to this peer. A
prefix that is filtered out (deny) will not be exported. A prefix that is filtered in (accept) will be
exported.
If no export policy is specified, all FEC prefixes learned will be exported to this LDP peer. This
policy is applied in addition to the global LDP policy and targeted session policy.
Policies are configured in the config>router>policy-options context. A maximum of five policy
names can be specified. Peer address has to be the peer LSR-ID address.
The no form of the command removes the policy from the configuration.
Default no export-prefixes - no export route policy is specified
Parameters policy-name — The export-prefix route policy name. Allowed values are any string up to 32
characters long composed of printable, 7-bit ASCII characters excluding double quotes. If the
string contains spaces, use double quotes to delimit the start and end of the string. The specified
name(s) must already be defined.

Table of Contents

Other manuals for Alcatel-Lucent 7450

Related product manuals