Page 684 7450 ESS MPLS Guide
TCP Session Parameters Commands
tcp-session-parameters
Syntax tcp-session-parameters
Context config>router>ldp
Description This command enables the context to configure parameters applicable to TCP transport session of an
LDP session to remote peer.
peer-transport
Syntax peer-transport ip-address
no peer transport
Context config>router>ldp>tcp-session-parameters
Description This command configures the peer transport address, that is, the destination address of the TCP
connection, and not the address corresponding to the LDP LSR-ID of the peer.
Parameters ip-address —
The IPv4 or IPv6 address of the TCP connection to the LDP peer in dotted dec-
imal notation.
auth-keychain
Syntax auth-keychain name
Context config>router>ldp>tcp-session-parameters>peer-transport
Description This command configures TCP authentication keychain to use for the session.
Parameters name — Specifies the name of the keychain to use for the specified TCP session or sessions. This
keychain allows the rollover of authentication keys during the lifetime of a session up to 32
characters in length. Peer address has to be the TCP session transport address.
authentication-key
Syntax authentication-key [authentication-key | hash-key] [hash | hash2]
no authentication-key
Context config>router>ldp>tcp-session-parameters>peer-transport
Description This command specifies the authentication key to be used between LDP peers before establishing
sessions. Authentication uses the MD-5 message-based digest. Peer address has to be the TCP
session transport address. Note that if one or more transport addresses used in the Hello adjacencies
To Next Page
Loading...
