Show Commands
Page 742 7450 ESS MPLS Guide
discovery
Syntax discovery [{peer [ip-address]} | {interface [ip-int-name]}] [state state] [detail] [adjacency-
type type]
discovery [state state] [detail|summary] [adjacency-type type] [session ip-addr[label-
space]]
discovery [state state] [detail|summary] [adjacency-type type] [family]
discovery interface [ip-int-name] [state state] [detail|summary] [session ip-addr[label-
space]]
discovery peer [ip-address] [state state] [detail|summary] [session ip-addr[label-space]]
Context show>router>ldp
Description This command displays the status of the interfaces participating in LDP discovery.
Parameters peer ip-address — Specifies to display the IP address of the peer.
interface ip-int-name — The name of an existing interface. If the string contains special characters
(#, $, spaces, etc.), the entire string must be enclosed within double quotes.
state state — Specifies to display the current operational state of the adjacency.
Values established, trying, down
detail — Specifies to display detailed information.
family — Displays either IPv4 or IPv6 LDP session information.
adjacency-type type — Specifies to display the adjacency type.
Values link, targeted
Output LDP Discovery Output — The following table describes LDP discovery output fields.
Label Description
Interface Name
The name of the interface.
Local Addr
The IP address of the originating (local) router.
Peer Addr
The IP address of the peer.
Adj Type
The adjacency type between the LDP peer and LDP session is targeted.
State
Established — The adjacency is established.
Trying — The adjacency is not yet established.
No. of Hello Adja-
cencies
The total number of hello adjacencies discovered.
Up Time
The amount of time the adjacency has been enabled.
Hold-Time Remain-
ing
The time left before a neighbor is declared to be down.
To Next Page
Loading...
