Alcatel-Lucent 7450 - Page 764

Show Commands
Page 764 7450 ESS MPLS Guide
10.0.10.23 10.0.10.24
10.0.10.25 10.0.10.26
10.0.10.27 10.0.10.28
10.0.10.29 10.0.10.30
10.0.10.31 10.0.10.32
10.0.10.33 10.0.10.34
10.0.10.35 10.0.10.36
10.0.10.37 10.0.10.38
10.0.10.39 10.0.10.40
10.0.10.41 10.0.10.42
10.0.10.43 10.0.10.44
10.0.10.45 10.0.10.46
10.0.10.47 10.0.10.48
10.0.10.49 10.0.10.50
-------------------------------------------------------------------------------
Peer Template templ3
-------------------------------------------------------------------------------
30.1.3.5 30.1.3.6
30.1.3.7 30.1.3.8
30.1.3.9 30.1.3.10
30.1.3.11 30.1.3.12
30.1.3.13 30.1.3.14
===============================================================================
session-parameters
Syntax session-parameters [family]
session-parameters peer-ip-address
Context show>router>ldp
Description This command displays LDP peer information.
Parameters peer-ip-address — Specify the peer IP address.
family — Displays either IPv4 or IPv6 active LDP information.
LDP session-parameters output — The following table describes LDP session-parameters
output.
Label Description
Peer
The IP address of the peer.
TTL security
Enabled — LDP peering sessions protected.
Disabled — LDP peering sessions unprotected.
Min-TTL-Value
Displays the minimum TTL value for an incoming packet.
Auth
Enabled — Authentication using MD5 message based digest proto-
col is enabled.
Disabled — No authentication is used.