Publication 1766-RM001A-EN-P - October 2008
Communications Instructions 433
“This Controller” Parameters
Channel
You must select Channel 1 (Integral) to use Ethernet pathways for
messaging.
Communication Command
The controller supports seven different types of communication
commands. If the target device supports any of these command types, the
controller should be capable of exchange data with the device. You can
use one of the seven kinds of message commands, 500CPU, 485CIF, PLC5
and CIP Generic[. Refer to the previous examples for the usage of each
command.
efesotomasyon.com - Allen Bradley,Rockwell,plc,servo,drive
To Next Page
Loading...
