Rockwell Automation Publication 2711P-AP006C-EN-P - November 2018 47
Chapter 3
Import Your Application
Introduction
In this chapter, you import your existing PanelBuilder®32 application into
FactoryTalk® View Machine Edition (ME) software.
Different software is used by the PanelView™ Standard and PanelView Plus 7
platforms to develop applications.
• PanelView Standard terminals run applications that are created with
PanelBuilder32 software.
• PanelView Plus 7 terminals run applications that are created with
FactoryTalk View ME software.
Before You Begin
• Review the migration considerations (Chapter 1).
• Select a PanelView Plus 7 terminal replacement and adapter kit, if
necessary (Chapter 2).
• Optionally install the PanelView Plus 7 terminal replacement
(Chapter 2). You can install the terminal after migrating and testing
your application.
What You Need
• FactoryTalk View Studio for Machine Edition software with correct
version for your PanelView Plus 7 terminal. Refer to
Required Software
on page 10 for details.
• PanelBuilder32 .pba application file.
The application file can reside on your local hard disk drive or external
storage media:
– Secure Digital (SD) card or USB flash drive for PanelView Plus 7
terminals.
– USB flash drive for PanelView Plus 7.
To Next Page
Loading...
