User Manual – Rev BE AMETEK Programmable Power
MX Series 148
VOLT MODE Sets the power-on voltage mode. Available settings are
AC mode, DC mode or AC+DC mode.
OL MODE Sets the power-on overload mode. Available settings
are Constant Current (CC) or Constant Voltage (CV)
mode.
OUTPUT RELAY Sets the power-on state of the output relay. Available
settings are ON or OFF.
INITIAL SETUP 3
VOLT SENSE Sets the power-on state of the voltage sense mode.
Available settings are Internal (INT) or External (EXT).
WAVE GROUP [3Pi Controller only] Sets the user defined waveform
group that will be loaded at power on. Available groups
are 0, 1, 2 and 3. Each group can contain up to 50
user-defined waveforms. A waveform group can only be
loaded at power up. To change groups, you must
change this field to the desired new group and cycle the
power to the AC source or issue a *RST command over
one bus.
CLOCK MODE Sets the clock source used at power up. Available
settings are Stand Alone (STAND), MASTER (-LKM clock
and lock master), and AUX (-LKS clock and lock
auxiliary).
NO. OUTPUT [MX30-3Pi or MX45-3Pi model only] Sets the phase
mode at power up. Available options are single-phase
mode (ONE), three-phase mode (THREE) or last used
phase mode (LAST). If the phase mode option is not
installed, this field is fixed to ONE or THREE.
VOLT ALC Determines ALC mode at power on. The ALC mode
adjusts the output voltage based on internal voltage
measurement system and provides enhanced output
regulation and accuracy. Available settings are ON, OFF
or REG (Series II only).
To Next Page
Loading...
