User Manual – Rev BE AMETEK Programmable Power
MX Series 184
the desired phase, as described in the example. Note that fields common to all
phases such as DURATION, END DELAY and REPEAT always apply to all three
phases in three-phase mode. When the cursor is moved to any of these fields,
the phase enunciator in the top right-hand corner always reverts to øABC.
Frequency transients are identical to voltage transients except they always
apply to all three phases in a three-phase configuration.
4.7.6 Programming Slew Rates
As shown in the previous examples there are several ways that you can
generate custom waveforms. Programmable slew rates provide additional
flexibility when customizing waveforms. Slew rates determine how fast the
voltage or frequency is changed by the controller when a step, pulse, or list
transient is triggered. Slew rates cannot be programmed from the front panel
and are always set to their maximum values at power on. To use programmable
slew rates, the AC source must be programmed over the bus. Refer to the SCPI
Programming Manual for more information about programming slew rates.
To Next Page
Loading...
