AMSTRAD E3 e-m@iler - Page 165

Reference information
- 163 -
You may wish to cut-out and keep this section hidden:
+
Removing all user PINs
If you have forgotten your user PIN or Parental Lock code, the following procedure
allows you to remove them all (in other words, reset them to 0000).
1. Press SETUP, 1 so that the top line of the display reads
SET UP - INFORMATION.
2. Type in 4 9 6 7.
3. Check that the message ALL PIN NUMBERS NOW RESET appears towards
the bottom of the display – if it doesn't, then repeat step 2.
4. Press STOP twice to return to the standby display.
♦ After resetting all PINs, each user will have to set up a new PIN or Parental Lock
code (if required).
Remote message access codes
Below is a cut-out and keep reminder on how to access your e-m@iler and
playback VoiceMail messages from another phone:
+
1
play
messages
2
play
outgoing
3
record
outgoing
4
email collect
-manual
5
email collect
-polling
6
email collect
-auto
7
VoiceMail
off
8
delete
message
9
VoiceMail
on
✱
previous
message
0
stop
#
next
message
1. Call your own number and wait until you
hear your outgoing message playing.
2. Key-in ✱ followed by your remote access
code:
1
✱
11 I
(If you haven't previously set up a code,
key in ✱1234).
3. Wait for the 3 beeps.
4. Dial one of the options shown on the
right.