7-11 [:SENSe] Subsystem Fixed WiMAX Commands
7-30 PN: 10580-00319 Rev. N S412E PM
[:SENSe]:POWer[:RF]:RANGe:AUTO OFF|ON|0|1
[:SENSe]:POWer[:RF]:RANGe:AUTO?
Title: Automatic Amplitude Range
Description: Sets the automatic amplitude range. Setting the value to ON or 1 will
result in the amplitude range being coupled to the detected input signal
level. Setting the value to OFF or 0 will result in the input attenuation
being un-coupled from the input signal level. That is, changing the
input signal level will not change the amplitude range. When this
command is issued, the amplitude range itself will
not change. The
default value is ON. That is, sending :SENS:POW:RANG:AUTO
is
equivalent to sending :SENS:POW:RANG:AUTO ON.
Parameter: OFF|ON|0|1
Parameter Type: <boolean>
Default Value: ON
Related Command: :POWer[:RF]:RANGe
Front Panel Access: Amplitude, Auto Range
[:SENSe]:POWer[:RF]:RANGe[:IMMediate]
Title: Amplitude Range
Description: Re-calculates amplitude range. Note that issuing this command will set
the automatic dynamic range OFF.
Related Command: :POWer[:RF]:RANGe:AUTO
Front Panel Access: Amplitude, Adjust Range
[:SENSe]:RF:ACPR:ADJCchannelcount?
Title: ACPR ADJC Channel Count
Description: Returns the number of Adjacent channels in the ACPR view.
Range: 1 to 4
[:SENSe]:RF:ACPR:MAINchannelcount?
Title: ACPR MAIN Channel Count
Description: Returns the number of main channels in the ACPR view.
Range: 1 to 4
[:SENSe]:RF:PVTime:FRAMe:STARt?
Title: Power vs. Time Frame Start Time
Description: Queries the Power vs. Time Frame start time.
Default Unit: seconds
Related Command: :RF:PVTime:FRAMe:STOP?
:DLFLength?
To Next Page
Loading...
