8-2 :CONFigure Subsystem Mobile WiMAX Commands
8-2 PN: 10580-00319 Rev. N S412E PM
8-2 :CONFigure Subsystem
This set of commands prepares the instrument for the selected measurement. It disables any
currently-enabled measurements and activates the specified measurement. It sets the
instrument to single sweep mode, waiting for an :INITiate command. It will not initiate the
taking of a measurement.
Current instrument settings may be changed to default values. These changes are identified
with their respective measurement commands.
:CONFigure PFail
Title: Configure PASS/FAIL Measurement
Description: This command configures the PASS/FAIL measurement. It disables any
other active measurements. None of the instrument parameters are
changed by the execution of this command. Sets the instrument to
single sweep mode (:INITiate:CONTinuous OFF). Measurement
settings can be modified by using the [:SENSe] commands before
initiating a measurement. The measurement results are equivalent to
the results that are displayed by choosing Measurements, then
PASS/FAIL from the front panel.
Parameter: PFail
Related Command: :FETCh:PFail?
MEASure:PFail?
READ:PFail?
Front Panel Access: Measurements, Pass/Fail Mode
:CONFigure SUMMary
Title: Configure Summary Measurement
Description: This command configures the summary of all the related numerical
measurement results. It disables any other active measurements. None
of the instrument parameters are changed by the execution of this
command. Sets the instrument to single sweep mode
(:INITiate:CONTinuous OFF). Measurement settings can be modified
by using the [:SENSe] commands before initiating a measurement.
Parameter: SUMMary
Parameter Type: <char>
Front Panel Access: Measurements, WiMAX Summary
To Next Page
Loading...
