Mobile WiMAX Commands 8-7 :MEASure Subsystem
S412E PM PN: 10580-00319 Rev. N 8-13
Data is returned as 8 comma-delimited values: EVM (rms) in %, EVM
(pk) in %, RCE (rms) in dB, RCE (pk) in dB, Carrier Frequency in MHz,
Freq Error in MHz, Freq Error in ppm, and the Base Station ID.
Related Command: :READ:DEMod:EVSCarrier?
:CONFigure:DEMod EVSCarrier
:MEASure:DEMod:EVSYmbol?
Title: Measure EVM vs. Symbol
Description: Sets the active measurement to EVM vs. Symbol, sets the default
measurement parameters, triggers a new measurement, and returns
the EVM (rms), EVM (pk), RCE (rms), RCE (pk), Carrier Frequency,
Freq Error, Freq Error, and the Base Station ID. It is a combination of
the commands :CONFigure:DEMod EVSYmbol and
:READ:DEMod:EVSYmbol? To make an EVM vs. Symbol measurement
with settings other than the default values, send:
:CONFigure:DEMod EVSYmbol
Commands to set the desired settings
:READ:DEMod:EVSYmbol?
Data is returned as 8 comma-delimited values: EVM (rms) in %, EVM
(pk) in %, RCE (rms) in dB, RCE (pk) in dB, Carrier Frequency in MHz,
Freq Error in MHz, Freq Error in ppm, and the Base Station ID.
Related Command: :READ:DEMod:EVSYmbol?
:CONFigure:DEMod EVSYmbol
:MEASure:DEMod:SFLatness?
Title: Measure Spectral Flatness
Description: Sets the active measurement to Spectral Flatness, sets the default
measurement parameters, triggers a new measurement, and returns
the absolute delta of the power between adjacent sub carriers in dB. It is
a combination of the commands :CONFigure:DEMod SFLatness and
:READ:DEMod:SFLatness? To make a Spectral Flatness measurement
with settings other than the default values, send:
:CONFigure:DEMod SFLatness
Commands to set desired settings
:READ:DEMod:SFLatness?
Related Command: :READ:DEMod:SFLatness?
:CONFigure:DEMod SFLatness
To Next Page
Loading...
