8-7 :MEASure Subsystem Mobile WiMAX Commands
8-14 PN: 10580-00319 Rev. N S412E PM
:MEASure:PFail?
Title: Measure PASS/FAIL
Description: Sets the active measurement to PASS/FAIL, sets the default
measurement parameters, triggers a new measurement and returns the
PASS/FAIL results. It is a combination of the commands :CONFigure
PFail and :READ:PFail? To make a PASS/FAIL measurement with
settings other than the default values, send:
:CONFigure PFail
Commands to set desired settings
:READ:PFail?
Related Command: :CONFigure PFail
:READ:PFail?
:FETCh:PFail?
Front Panel Access: Measurements, Pass/Faile Mode
:MEASure:RF:ACPR?
Title: Measure Adjacent Channel Power Ratio
Description: Sets the active measurement to ACPR, sets the default measurement
parameters, triggers a new measurement, and returns the power levels
for each channel (both absolute and relative). It is a combination of the
commands :CONFigure:RF ACPR and :READ:RF:SPECtrum? To make
an RF ACPR measurement with settings other than the default values,
send:
:CONFigure:RF ACPR
Commands to set desired settings
:READ:RF:ACPR?
Data is returned as 11 comma-delimited values: The Channel Power in
dBm, relative adjacent channel 1 power level, absolute adjacent channel
1 power level, relative adjacent channel 2 power level, absolute adjacent
channel 2 power level, relative adjacent channel 3 power level, absolute
adjacent channel 3 power level, relative adjacent channel 4 power level,
absolute adjacent channel 4 power level, relative adjacent channel 5
power level, absolute adjacent channel 5 power level. The relative
adjacent channel power level is in dB and the absolute adjacent channel
power level is in dBm.
Related Command: :READ:RF:ACPR?
:CONFigure:RF ACPR
:FETCh:RF:ACPR?
Front Panel Access: Measurements, RF Measurements, ACPR
To Next Page
Loading...
