Mobile WiMAX Commands 8-7 :MEASure Subsystem
S412E PM PN: 10580-00319 Rev. N 8-15
:MEASure:RF:PVTime?
Title: Measure Power vs. Time
Description: Sets the active measurement to Power vs. Time, sets the default
measurement parameters, triggers a new measurement and returns the
Channel Power, Preamble power, burst power of data bursts, and the
Crest Factor. It is a combination of the commands :CONFigure:RF
PVTime and :READ:RF:PVTime? To make an RF ACPR measurement
with settings other than the default values, send:
:CONFigure:RF PVTime
Commands to set desired settings
:READ:RF:PVTime?
Data is returned as 4 comma-delimited values: The Channel Power in
dBm, Preamble power in dBm, burst power of data bursts in dBm, and
the Crest Factor in dB.
Related Command: :READ:RF:PVTime?
:CONFigure:RF PVTime
:MEASure:RF:SPECtrum?
Title: Measure RF Spectrum
Description: Sets the active measurement to Spectrum, sets the default
measurement parameters, triggers a new measurement and returns the
Channel Power (RSSI) and Occupied bandwidth measurement. It is a
combination of the commands :CONFigure:RF SPECtrum and
:READ:RF:SPECtrum? To make an RF Spectrum measurement with
settings other than the default values, send:
:CONFigure:RF SPECtrum
Commands to set desired settings
:READ:RF:SPECtrum?
Data is returned as 2 comma-delimited values: Channel Power (RSSI)
in dBm Occupied bandwidth measurement in MHz.
Related Command: :CONFigure:RF SPECtrum
:READ:RF:SPECtrum?
:FETCh:RF:SPECtrum?
Front Panel Access: Measurements, RF Measurements, Channel Spectrum
To Next Page
Loading...
