Mobile WiMAX Commands 8-10 :TRACe Subsystem
S412E PM PN: 10580-00319 Rev. N 8-23
Use the commands in the MMEMory subsystem to store and recall
traces from the instrument memory. Except for CONStln there is only
one value per data point. If max hold is set to ON for SPECtrum and
EVM vs. Sub Carrier then the max hold value is returned. For
CONStln, each data point is represented by 3 values 4 bytes each: IData
(no units), QData (no units), and the constellation type (no units). For
SPECtrum and PVTime unit is in dBm. For Spectral Flatness unit is in
dB. For EVM vs Sub Carrier and EVM vs Symbol unit is in percent.
Note that the instrument must be set in the selected view. Use the
CONFigure command to set the unit to the selected view.
Parameter: <trace type>
Related Command: :FORMat[:DATA]
:TRACe[:DATA]:PREamble?
To Next Page
Loading...
