NXDN Commands 12-2 :CONFigure Subsystem
S412E PM PN: 10580-00319 Rev. N 12-3
:CONFigure:BITCap
Description: This command configures the NXDN Bit Capture measurement.
Certain settings from the previous measurement (Ref Lvl, Scale, Graph
Types, Maximize) will be backed up when exiting this measurement and
restored when entering this measurement. All other settings carry over
from one measurement to the other. Please note that you must have the
Rx pattern set to VOICe to set the NXDN Bit Capture measurement.
Cmd Parameters: NA
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To switch the measurement to NXDN Bit Capture:
:CONFigure:BITCap
Related Command: :DM:PATTern VOICe
Front Panel Access: Measurement, NXDN Bit Capture
:CONFigure:CONTrol
Description: This command configures the NXDN Control measurement. Certain
settings from the previous measurement (Ref Lvl, Scale, Graph Types,
Maximize) will be backed up when exiting this measurement and
restored when entering this measurement. All other settings carry over
from one measurement to the other. Please note that you must have the
Rx pattern set to VOICe or CTRLchan to set the NXDN Control
measurement.
Cmd Parameters: NA
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To switch the measurement to NXDN Control:
:CONFigure:CONTrol
Related Command: :DM:PATTern VOICe
:DM:PATTern CTRLchan
Front Panel Access: Measurement, NXDN Control
To Next Page
Loading...
