DMR 2 Commands 14-9 :READ Subsystem
S412E PM PN: 10580-00319 Rev. N 14-25
The received power will be returned in the unit that is selected through
the Rx Units button on the front panel or with the command:
UNIT:POWer:RX. If the receiver unit has been set to dBm, the received
power is returned in dBm. If the unit is set to Watts, the received power
is returned in fW (10
-15
W). If the unit is set to Volts, the received power
is returned in fV (10
-15
V).
Note: This command is not affected by the squelch level set using the
front panel.
Cmd Parameters: NA
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To read DMR 2 Analyzer numerical data:
:READ:SIGAnalyzer?
Related Command: :CONFigure:SIGAnalyzer
Front Panel Access: NA
To Next Page
Loading...
