Spectrum Analyzer Commands 4-2 :CALCulate Subsystem
S412E PM PN: 10580-00319 Rev. N 4-7
:CALCulate:LIMit:MIRRor
Title: Limit Mirror
Description: Creates a limit mirror. Use :CALCulate:LIMit:TYPe to set the currently
active limit line.
Related Command: :CALCulate:LIMit:TYPe
:CALCulate:LIMit:POINt:ADD
Title: Add Limit Point
Description: Adds a new limit point to the currently active limit line. Use
:CALCulate:LIMit:TYPe to set the currently active limit line.
Related Command: :CALCulate:LIMit:TYPe
Front Panel Access: Shift-6 (Limit), Limit Edit, Add Point
:CALCulate:LIMit:POINt:DELete
Title: Delete Limit Point
Description: Deletes the currently active limit point. The active point becomes the
point that is immediately to the left of the point that was deleted. Note
that deletion is only valid if there are more than 2 limit points. Use
:CALCulate:LIMit:TYPe to set the currently active limit line.
Example: To delete the currently active limit point:
:CALCulate:LIMit:POINt:DELete
Front Panel Access: Shift-6 (Limit), Limit Edit, Delete Point
:CALCulate:LIMit:POINt:LEFT
Title: Next Point Left
Description: Selects the limit point immediately to the left of the active point,
making it active for editing or deleting. Use :CALCulate:LIMit:TYPe to
set the currently active limit line.
Example: To select the point to the left of the active point:
:CALCulate:LIMit:POINt:LEFT
Front Panel Access: Shift-6 (Limit), Limit Edit, Next Point Left
:CALCulate:LIMit:POINt:RIGHt
Title: Next Point Right
Description: Selects the limit point immediately to the right of the active point,
making it active for editing or deleting. Use :CALCulate:LIMit:TYPe to
set the currently active limit line.
Example: To select the point to the right of the active point:
:CALCulate:LIMit:POINt:RIGHt
Front Panel Access: Shift-6 (Limit), Limit Edit, Next Point Right
To Next Page
Loading...
