4-2 :CALCulate Subsystem Spectrum Analyzer Commands
4-6 PN: 10580-00319 Rev. N S412E PM
:CALCulate:LIMit:LOWer[:STATe] OFF|ON|0|1
:CALCulate:LIMit:LOWer[:STATe]?
Title: Lower Limit State
Description: Turns the lower limit line ON or OFF. It is a combination of the
commands :CALCulate:LIMit:TYPe 1 and :CALCulate:LIMit:STATe
ON|OFF. The query version of the command returns a 1 if the lower
limit line is ON and returns a 0 if OFF.
Parameter: OFF|ON|0|1
Parameter Type: <boolean>
Default Value: OFF
Example: To turn on lower limit:
:CALCulate:LIMit:LOWer ON
:CALCulate:LIMit:LOWer 1
:CALCulate:LIMit:LOWer:STATe ON
To turn off lower limit:
:CALCulate:LIMit:LOWer OFF
:CALCulate:LIMit:LOWer 0
:CALCulate:LIMit:LOWer:STATe 0
Related Command: :CALCulate:LIMit:ALARm
Front Panel Access: Shift-6 (Limit), Limit Lower, Limit On/Off
:CALCulate:LIMit:LTYPe ABSolute|RELative
:CALCulate:LIMit:LTYPe?
Title: Limit Line Type
Description: Sets the currently active limit line type. Absolute limit lines set the
limit inflection points based upon the entered frequencies for each
point. Relative limit lines set the limit inflection points relative to the
current center frequency.
Parameter: ABSolute|RELative
Parameter Type: <char>
Default Value: ABSolute
Range: ABSolute|RELative
Example: To set the limit line type to relative:
:CALCulate:LIMit:LTYPe RELative
Related Command: :CALCulate:LIMit[:STATe]
Front Panel Access: Shift-6 (Limit), Limit Advanced, Limit Line Type
To Next Page
Loading...
