NBFM Commands 16-13 [:SENSe] Subsystem
S412E PM PN: 10580-00319 Rev. N 16-45
[:SENSe]:DEV:MODE PEAK|RMS|AVERage
[:SENSe]:DEV:MODE?
Description: Sets the deviation mode that is displayed in the NBFM Analyzer
summary table, 3rd row down. The query will return PEAK for peak,
RMS for RMS, and AVER for average.
Cmd Parameters: PEAK|RMS|AVERage
Query Parameters: NA
Range: PEAK|RMS|AVER
Default Value: PEAK
Default Unit: NA
Example: To set the deviation mode to average:
:DM:PATTern AVER
Front Panel Access: Setup, Deviation Mode
[:SENSe]:DM:PATTern CTCSs|DCS|DTMF
[:SENSe]:DM:PATTern?
Description: Sets the tone type. Setting the tone type will change the 8th numeric
value in the summary window to readout the chosen tone type. The
query will return CTCSS for CTCSS, DCS for DCS, and DTMF for DTMF.
Please note that setting the tone type will restart the sweep.
Cmd Parameters: CTCSs|DCS|DTMF
Query Parameters: NA
Range: CTCSs|DCS|DTMF
Default Value: CTCSs
Default Unit: NA
Example: To set the modulation type to DTMF
:DM:PATTern DTMF
Front Panel Access: Setup, To ne Ty p e
[:SENSe]:FILTer:DEMPhasis[:STATe] OFF|ON|0|1
[:SENSe]:FILTer:DEMPhasis[:STATe]?
Description: Sets the de-emphasis filter on or off.
Cmd Parameters: OFF|ON|0|1
Query Parameters: NA
Range: OFF|ON|0|1
Default Value: OFF
Default Unit: NA
Example: To turn the de-emphasis filter on:
:FILTer:DEMPhasis ON
Front Panel Access: Setup, Filter, De-emphasis Filter
To Next Page
Loading...
