Anritsu LMR Master S412E - Page 656

18-7 [:SENSe] Subsystem AM/FM/PM Commands
18-14 PN: 10580-00319 Rev. N S412E PM
[:SENSe]:AFPanalyzer:DEMod:TYPE AM|FM|PM
[:SENSe]:AFPanalyzer:DEMod:TYPE?
Title: Demodulation Type
Description: This command sets the demodulation type.
Parameter: AM|FM|PM
Default Value: AM
Example: To set the demodulation type to FM:
SENSe:AFPanalyzer:DEMod:TYPE FM
Front Panel Access: Setup, Demod Type
[:SENSe]:AFPanalyzer:FM:SCALe <percentage>
[:SENSe]:AFPanalyzer:FM:SCALe?
Title: FM Y-axis reference level percentage
Description: This command sets the Y-axis reference level as the percentage of the IF
bandwidth in the FM Audio spectrum/waveform display.
Parameter: <percentage>
Default Value: 50
Default Unit: %
Range: 0% to 100%
Front Panel Access: Shift-4 (Measure), Audio Spectrum/Waveform, Scale: % IFBW
[:SENSe]:AFPanalyzer:IFBW <freq>
[:SENSe]:AFPanalyzer:IFBW?
Title: IF bandwidth
Description: Sets the IF bandwidth. Note that using this command turns the
automatic IF bandwidth setting OFF.
Parameter: <freq>
Default Value: 300 kHz
Default Unit: Hz
Range: 1 kHz to 300 kHz in a 1:3 sequence
Related Command: :AFPanalyzer:IFBW:AUTO
Front Panel Access: Setup, IFBW