Anritsu LMR Master S412E - Page 657

AM/FM/PM Commands 18-7 [:SENSe] Subsystem
S412E PM PN: 10580-00319 Rev. N 18-15
[:SENSe]:AFPanalyzer:IFBW:AUTO 0|1
[:SENSe]:AFPanalyzer:IFBW:AUTO?
Title: IF bandwidth coupling
Description: Sets the state of the coupling of the IF bandwidth to the span. Setting
the value to 1 will result in the IF bandwidth being coupled to the span.
That is, when the span changes, the IF bandwidth changes. Setting the
value to 0 will result in the IF bandwidth being un-coupled from the
span. That is, changing the span will not change the IF bandwidth.
Parameter: 0|1
Parameter Type: <boolean>
Default Value: 1
Front Panel Access: Setup, Auto IFBW
[:SENSe]:AFPanalyzer:PM:SCALe <Radians>
[:SENSe]:AFPanalyzer:PM:SCALe?
Title: PM Y-axis reference level
Description: This command sets the Y-axis reference level in the PM Audio
spectrum/waveform display.
Parameter: <number>
Default Value: 3.140
Range: 3.140 to 3140
Front Panel Access: Shift-4 (Measure), Audio Spectrum/Waveform, Scale: milli-Rad
[:SENSe]:AFPanalyzer:RFSPectrum:DATA?
Title: Summary data
Description: This query returns the measurment values in the RF spectrum view.
The order of the values are as follows:
<carrier power> in dBm, <carrier freq> in Hz, <Occ BW> in Hz. All
values are comma separated.
Front Panel Access: Shift-4 (Measure), RF Spectrum.
[:SENSe]:AFPanalyzer:SPAN <freq>
[:SENSe]:AFPanalyzer:SPAN?
Title: Audio Frequency Span
Description: Sets the audio frequency span in the audio spectrum view. Valid values
are 2 kHz, 5 kHz, 10 kHz, 20 kHz and 70 kHz.
Parameter: <freq>
Default Unit: Hz
Front Panel Access: Shift-4 (Measure), Audio Spectrum, Span