ASE2000 V2 Communication Test Set User Manual 118
In the Post-Driver Installation screen shot, there are two new sets of entries. Under Ports (COM
& LPT) the COM ports ASE-BCOM-USB Comm Port (COM9) and (COM10) have been added
and under Universal Serial Bus controllers two CDC Applied Systems enumerator entries have
been added, one for each BCOM-USB COM port.
3. Identify the location containing the I/O Driver les to be used for the installation. In the steps
below, it will be necessary to “point” the windows installer to this folder. The les can be
obtained from the ASE2000 Communication Test Set installation CD or downloaded from the
ASE web site at:
http://www.ase-systems.com/ASE2000-test-set/ase2000-downloads.asp
This section contains the step-by-step instructions for the actual driver installation. Please follow
the steps carefully and verify the results of each step with the corresponding screen shots. Due
to system variations, some information may be slightly dierent but the general content should
be similar.
1. Connect the USB cable between the BCOM-USB device and the PC. Upon connection,
Windows will read certain device information from the BCOM-USB device and attempt to
locate a previously installed I/O driver for the device. Since no driver has been previously
installed, Windows will be unsuccessful in locating the driver and will display the following
screens. Initially, a small message block will be shown in the lower left corner of the screen
indication the attempt to install the driver with a “Click Here” target to display details.
2. Click the indicated target to see the screen shown below. Depending on previous driver
To Next Page
Loading...
Need help?
General
