ASE2000 V2 Communication Test Set User Manual 131
When you double-click on the le name or select “Open”, the program will write the new license
le to the BCOM-USB device. If the update is successful, the following message will appear:
22.4. ASE License/Firmware Updater New Firmware Installation
The ASE License/Firmware Updater is also used to install new rmware in the BCOM-USB
device. The BCOM-USB device was released in April 2009 and, although it underwent extensive
testing prior to release, it is possible that new releases of the rmware will be necessary to
correct problems found after shipment. Registered users will be notied by e-mail of new rmware
releases and new release notices will also be posted and available for download from the ASE
website at www.ase-systems.com.
Save the new Firmware le in a convenient place on the PC hard drive and start the ASE License/
Firmware Updater program:
To Next Page
Loading...
Need help?
General
