ASE2000 V2 Communication Test Set User Manual 148
25.2.3. Conitel – Task Mode RTU Simulation
Task Mode RTU Simulation utilizes the RTU and Point Data previously conîš¿gured for the device
to generate responses to master commands for data values.
When RTU Simulation mode is selected
, the Raw and Increment îš¿elds on the Point
List view are enterable. This provides the capability of changing the simulation value for individual
points and to control whether the value will change (Increment value) on successive scans.
Another method to change simulation values for individual points is to send control commands
from the Master as described in the next section.
To Next Page
Loading...
Need help?
General
