ASE2000 V2 Communication Test Set User Manual 168
26.4.6. DNP3 – Secure Auth. V5 Sub-Tab (Serial and LAN/WAN)
Full support for Secure Authentication Version 5 is available only when operating in Task Mode.
In Task Mode, messages can be sent with correct Secure Authentication values, and security of
incoming messages can be validated. In Exchange Mode, only Secure Authentication message
parsing is supported, allowing messages with Secure Authentication functions and objects
to be displayed. Secure Authentication is discussed in detail in the section: DNP3 - Secure
Authentication Setup.
To Next Page
Loading...
Need help?
General
