CHAPTER 2 - General Preliminary Information 13
Instructions for use and warnings
Expert software
technician
Qualified technician able to:
• carry out preventive/corrective work on all software parts of the machine;
• access all parts of the machine for visual inspections, checking equipment conditions,
adjustments and calibrations.
Manufacturer’s qualified technician with proven experience and training on systems based on: PLC/PC
drives, etc. (knowledge of programming, machine functions, etc.) for complex operations such as:
• changing machine data;
• creating work programs;
• adjustment of drive parameters, etc. as he/she knows the production, technological and
construction cycle of the supplied machine.
He/she can work in the electrical panels, junction boxes, control equipment, etc. with live voltage only
if he/she is a person in charge of an electrical installation (i.e. suitable person - SP) (Refer to EN50110-
1).
The skills are electronic and/or software-based.
Manufacturer’s
Technician
Qualified technician employed by the Manufacturer and/or its supplier for complex operations, as
he/she knows the construction production cycle of the machine.
This person intervenes following requests from the user.
The skills are mechanical-based.
The qualifications indicated in the table on this page obligatorily fall under a category of persons defined as “trained person”.
An individual who has been informed, instructed and trained on the job and on any hazards resulting
from misuse. He/she also knows the importance of the safety devices, the accident prevention
regulations and the safe working conditions.
2.6 Symbols used in the manual
In order to establish with certainty what the skills and qualifications are of the operators assigned to the various tasks (start-up,
cleaning, routine maintenance), see the table below:
Symbol used to identify important warnings for the safety of the operator and/or the machine.
Symbol used to identify electrical hazards.
Symbol used to identify important information in the manual. The information also concerns the
safety of personnel involved in machine use.
To Next Page
Loading...