ARS Flexibowl 200 - Other Connections; Air Blow Connection (Optional); Mapping of Connections between the Control Devices

CHAPTER 5 - Transport and Installation 47
Instructions for use and warnings
5.5.4 Other connections
5.5.4.1 Air Blow connection (optional)
If the optional Air Blow component is present, connect as follows:
Step
Action
Picture
1
Connect a Ø6 mm air pipe from the “Air Blow” socket in
the control panel to the Air Blow unit.
5.5.4.2 Mapping of connections between the control devices
The Flexibowl® is supplied already wired. If necessary, below is a map of the connections between the control devices.
Pos.
Item
1
I/O INTERFACE CONNECTOR
2
I/O INTERFACE CONNECTOR
3
ETHERNET CONNECTION
4
ENCODER CONNECTOR
5
VAC POWER SUPPLY CONNECTOR
6
MOTOR POWER SUPPLY CONNECTOR